Herunterladen Diese Seite drucken

WERKU WK501400 Original Anleitungen Seite 5

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 24
ENG
ORIGINAL
of coating material or cleaning agent with which
the injury was caused
range of this airless gun is 310 Bar fluid pressure
Never aim the airless gun at any part of the
body
Never allow any part of the body to touch
the fluid stream
Do not allow body to touch a
leak in the fluid hose
of the airless gun
Gloves will not provide
protection against an injection injury
point the airless gun at anyone else
lock the airless gun trigger, shut the pump
off and release all pressure before servicing,
cleaning the tip or guard, changing tip, or leaving
unattended
Pressure will not be released by
turning off the motor
must be turned to prime to relieve the pressure
Refer to the pressure relief pressure described
in the pump manual
in place while spraying
some protection but is mainly a warning device
Always remove the spray tip before flushing
or cleaning the system
leaks from wear, kinking and abuse
inject material into the skin
before each use
Never use an airless gun
without a trigger lock and trigger guard in place
and in good working order
be rated at or above the maximum operating
pressure range of the airless gun
spray tips, extensions and hose
Explosion hazard due to incompatible materials
will cause severe injury or property damage
not use materials containing bleach or chlorine
Do not use halogenated hydrocarbon solvents
such as bleach, mildewcide, methylene chloride
trichloroethane
They are not compatible
with aluminum
Contact your coating material
supplier about the compatibility of material with
aluminum
Hazard: General
can cause severe injury or property damage
Read all instructions and safety precautions
before operating this airless gun
near sources of ignition; eg open flames,
cigarettes (also cigars and pipes are sources of
ignition), sparks, hot wires and hot surfaces, etc
Wear respiratory equipment when spraying
The operator must be provided with a protective
mask
In order to prevent work related illness,
the manufacturer's regulations for the materials,
The maximum operating
Never put hand in front
Never
Always
The prime/spray valve
Always keep the tip guard
The tip guard provides
The hose can develop
A leak can
Inspect the hose
All accessories must
This includes
Hazard:
This airless gun
Never spray
solvents, and cleaning agents used must be
observed when preparing, working with and
cleaning the airless gun
gloves, eyewear, and, in certain cases, protective
skin cream are necessary to protect the skin
Follow the coating material and solvent
manufacturer's warnings and instructions
Extraction equipment should be installed by
the user in accordance with local regulations
The objects being sprayed must be earthed
Before each use, check all hoses for cuts,
leaks, abrasion or bulging of cover
damage or movement of couplings
replace the hose if any of these conditions exist
Never repair a hose
grounded high-pressure hose
trigger causes a recoil force to the hand that
is holding the airless gun
the airless gun is particularly powerful when
the tip has been removed and a high pressure
has been set on the airless high-pressure pump
Therefore, when cleaning without tip set the
pressure control valve to the lowest pressure
Use only manufacturer authorized parts
assumes all risks and liabilities when using parts
that do not meet the minimum specifications and
safety devices of the airless gun manufacturer
Hazard: Any static-electricity discharge from
the airless gun is to be diverted to the grounded
high-pressure pump via the conductive high-
pressure hose as stipulated
Do
surface temperature corresponds to the
permissible material temperature
permissible ambient temperature can be found
in the technical data
of machine sparks, prevent impact stresses and
any work on the unit with tools in the explosion-
hazardous area.
RESIDUAL RISKS.
Residual risks are risks, which cannot be
excluded, even when equipment is used for the
intended purpose
areas of the actual residual risks will be pointed
out using warning and/or prohibition signs.
English
5
Protective clothing,
Check for
Immediately
Replace it with another
Pulling the
The recoil force of
The maximum
This and the
To avoid the generation
In such cases the applicable
User

Werbung

loading