Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FITTING INSTRCUTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
7
5
3
6
This towbar is designed to assembly in following cars:
HYUNDAI GET, 3/5 DOORS, produced since 09.2005 till 03.2009,
catalogue no. J53A and is prepared to tow trailers max total weight 1100 kg
and max vertical load 44 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
4
1
2
From manufacturer
1.
For the purpose of installings of the towbar one ought to disassemble the bumper, and
then unscrew the plastic fulfilment from the bumper.
7
2.
In the axis of the bumper make cut outs (see fig. 2).
3.
Cut off the fragment from the plastic fulfilment
(see fig. 3).
4.
Fix the brackets of the towbar (pos. 4 and 5) to
chassis members using bolts M12x1,25x35mm
(pos. 7) – loosely (see fig. 1).
5.
Slip the main bar of the towbar (pos. 1) between
installed brackets (pos. 4 and 5) and fix using
bolts M12x35mm (pos. 6).
6.
Tighten all bolts according to the torque shown in
the table.
7.
Install the bumper with the plastic reinforcement.
8.
Fix body of the automat and place tow-ball
according
to
Remember to place socket plate (pos. 3) as shown
on the drawing 1.
9.
Connect
electric
Fig. 1
according
to
(Recommend to make at authorized service
station).
10. Complete paint layer damaged during installation.
After install the towbar you should get adequate note in registration book (at authorised
service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always kept clear and
conserve with a grease.
The instruction of the assembly
90
supplied
instruction.
Note!
wires
of
7-poles
socket
the
instruction
of
the
car.
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 10 - 55 Nm
M 12 - 85 Nm
M 14 - 135 Nm
NOTE
Fig. 2
Plastic fulfilment
Fig. 3
Werbung
