Firmware Update - Hohem iSteady Mobile+ Benutzerhandbuch

Auto Calibration and Firmware Update
Calibration Reasons and How to Calibrate
Auto calibration can reduce drift or slight deviation caused by nearby magnetic
interference or human error.
Follow these steps for auto calibration:
Place the Gimbal on a flat surface using a tripod.
•
Double press the trigger button to recenter the Gimbal.
•
Press the mode button five times to start the auto calibration. Please avoid
•
touching the Gimbal during calibration.
Two beeps indicate that the calibration is completed. The Gimbal will recenter
•
and automatically return to normal operation.
Note:
If the Gimbal is not placed on a flat surface for calibration (e.g., hand-held
•
calibration in the car), it may cause calibration failure.
When the calibration fails, the Gimbal will make a beep sound, and all four mode
•
lights will flash, entering sleep mode. Single press any button (except the joystick)
to wake up the Gimbal and follow the above steps to try again

Firmware Update

If a new firmware update is available, you will be prompted in the Hohem Joy app.
Follow the on-screen instructions in the app to update the firmware.
FAQs
Why does the Gimbal automatically power off?
The Gimbal will automatically power off if no phone is installed or the phone is
•
not properly balanced, causing motor overload. A warning "beep" sound will be
emitted before the shutdown. Ensure correct phone installation and balance
before turning on the Gimbal, as detailed in the First Use section.
11