neno Uno Bedienungsanleitung Seite 15

3 times a day.
• Replace the tube only if moisture enters the tube or the tube is damaged.
09. THE BREAST PUMP
1. Wash your hands thoroughly with soap and water before touching the
breast pump and breast.
2. Attach the suction bowl and pumping device to the connector.
3. Connect the breast shield to the connector.
4. Put the valve in the connector.
5. Screw the milk bottle into the connector, rotating it clockwise until it can't
be turned anymore.
Tips:
a. Check the breast pump components for damage before each use. Repla-
ce damaged items with new ones as needed.
b. Always check the cleanliness of the elements before using the machine
c. To avoid damage to the breast pump, make sure that all its parts are dry
before using it.
10. CHARGING THE BREAST PUMP
Before the first use, charge the breast pump for 2 hours by connecting it to the
power supply using the USB cable. The battery icon on the display will be full when
charging is complete.
11. USING THE BREAST PUMP
SEE FIG. D
1. Place the breast shield on the breast so that the nipple is inside the drainage
channel.
2. Press the breast shield and the connector to your breast, using your thumb
and forefinger. Support your chest with the palm of your hand.
3. Turn on the breast pump by pressing the power button and select the mode
of operation that suits you.
4. Press the power button to turn off the breast pump after use and place the
lid on the breast shield to protect the machine from dust.
a. The breast pump starts work in the stimulation mode. Set the suction
power to a level that is comfortable for you using the +/- buttons.
Stimulation mode - fast pumping that mimics the natural sucking of breast
milk by a baby,stimulating milk flow
b. After 2 minutes, the breast pump will automatically activate the expres-
sion mode. Adjust the level of suction using the +/- buttons to find the
highest level of suction that is comfortable for you. If milk begins to flow
out of your breast before two minutes pass, press the mode button to
manually switch to the expression mode.
15