Cabletech UCH0150 Bedienungsanleitung Seite 5

1. Mount on Solid Brick
W-B
• When installing wall mounts on cinder block, verify the actual concrete thickness is at least
1-3/8" (35mm) for using the concrete anchors. Do not drill into mortar joints! Be sure to
mount in a solid part of the block, generally 1" (25mm) minimum from the side of the block.
It is suggested electric drill on slow setting
to avoid breaking out the back of the hole when entering
• Installers must verify that the supporting surface will safely support the combined load of the
equipment and all attached
User manual
and Concrete Block
A WARNING
is used to drill the hole instead
hardware and components.
60mm
ø 10m
Mark
exact
mounting
Drill pilot holes
W-A
of a hammer
a void or cavity.
the
location of
holes
Screw the wall
plate onto
the wall
drill