Woertz 49000/01 Bedienungsanleitung Seite 48

9. KNX programming
9.1 Channels
The gateway controls 2 DALI channels: CH1 (bus #1) and CH2 (bus #2). Each control channel
has the general, ballast (each individual ballast), group and scene channels as shown in
Figure 25.
9.2 Parameter
The parameters for general, ECG (each individual ballast) and group for each control
channel can be programmed separately. The parameter programming of CH1 is described
below. See CH1 for parameter programming of CH2.
9.2.1 CH1 General
Response to DALI power failure: means Response to CH1 DALI power failure, drop down
and tick a value, available settings: "no change", "maximum brightness value", "minimum
brightness value", "OFF" as shown in Figure 26 .
Bedienungsanleitung
Artikelnummer: 49000/01
DALI
P a g e |48
G00'314