The "Pair And Go" Automatic - AKE BC-102 Bedienungsanleitung

• BMW Communication System WCS-1
Activate helmet electronics
flashing (very fast)
Activate headset mode
flashing (slowly)
Activate solid connection
102 pocket repeater
the helmet, the LED is green (short activation of connection) and
shortly wait until the green light will flash again (disconnection).
Now shortly press Select/On/Off and when the LED is green, the
connection is permanently activated.
Disconnect helmet electronics

The "Pair and Go" automatic

The BlueCom 102
ble that after the first pairing and registering usually a reconnection
is made automatically, for example ...
- if the radio communication is clean again after an interruption
(e.g. due to exceeding the range or due to interferences)
- or simply after the
off and on again
Best always switch on the Bluetooth helmet set
and then¹ the BlueCom 102 pocket repeater.
¹) When switching on the pocket repeater, it will search for a Bluetooth helmet set. It
will confuse the automatic if the Bluetooth helmet set is switched on later (or off
and on again).
: Press Select/On/Off until green LED is
: Shortly press Select/On/Off, green LED is
: Shortly press button at the AKE
and wait until you hear the control signal in
: Press Select/On/Off twice
pocket repeater is developed to make it possi-
BlueCom 102
and put on the helmet first
pocket repeater was switched
BlueCom
13