Jata JBCP4200 Bedienungsanleitung Seite 21

- It is important to discharge the battery before it is
recharged, leave it on until it stops or the power
decreases clearly.
- The battery must be recharged every 6 months if it
has not been used for said period of time.
• Also recharge if it has not been used for more
than a month.
• Slide the on/off switch (3) to start operation.
• The display will show the time remaining after
use and the time of use, once the device has been
turned off by sliding the switch (3).
LUBRICATION
• For the hair clippers to work correctly it is
absolutely necessary to lubricate the blades
with oil before each use.
• Carefully pour a few drops of lubricating oil (8),
which is provided, between the teeth of the blade,
or if you have run out, with another high quality,
acid free oil.
• Turn the hair clippers on for a few seconds and
clean the excess oil off with a cloth.
CUTTING GUIDE
• The shaver have 5 cutting guides (1-2-3-4 and
5 mm) which allow to be accurately put into
different positions.
• Place the guide in the blade and press it to leave
it correctly fixed.
TRIMING BEARD
• Always remember you must begin with the
cutting guide set to the longest cutting position
before setting it in the lower position.
• Start by cutting from the down side of the chin and
moving the clipper with soft movements upwards
and outwards.
• For the final touches and the edges always use
the hair clipper without any guide.
REVIEW OF THE MOUSTACHE
• Comb the moustache downwards.
• Start with the guide in its longer position. Later
you may use the shorter cutting guides.
THE FINAL TOUCHES
• Do not use the guide for the final touches.
21