Maintenances And Servicing; Adding Oil (Rwh125Alu/Rwh180Alu); Adding Oil (Rwh250Alu); Bleeding - Holzmann Rwh125Alu Originalbetriebsanleitung

13

MAINTENANCES AND SERVICING

Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury from tool failure: Do not use damaged equipment. If abnormal noise or vibration oc-
curs, have the problem corrected before further use.
11.1
Before each use, inspect the general condition of the Jack. Check for broken, cracked, or bent parts,
loose or missing parts, and any condition that may affect the proper operation of the product. If a problem
occurs, have the problem corrected before further use .Do not use damaged equipment.
11.2
Before each use, thoroughly test the Jack for proper operation prior to its actual use. If the Jack ap-
pears not to be working properly, follow Bleeding instructions on page 2.
13.1

Adding Oil (RWH125ALU/RWH180ALU)

1. Remove Fill Screw and Screw simultaneously (Fig.1).
2. Add qualified hydraulic oil of high grade into the Fill Screw slowly until the oil reaches the top of the oil fill
hole.
Note: Do not touch the assembled Handle when adding the hydraulic oil.
3. Replace the Fill Screw and Screw.
13.2

Adding Oil (RWH250ALU)

1. Remove Fill Screw.
2. Add qualified hydraulic oil of high grade into the Fill Screw slowly until the oil reaches the top of the oil fill
hole.
Note: Do not touch the assembled Handle when adding the hydraulic oil.
3. Replace the Fill Screw.
13.3

Bleeding

1. Loosen the Fill Screw (Fig. 1).
2. Turn the Handle counterclockwise to open valve.
3. Pump the Handle up and down quickly for several times to purge the air from the system.
4.Tighten the Fill Screw (Fig. 1).
HOLZMANN Maschinen Austria  www.holzmann-maschinen.at
MAINTENANCES AND SERVICING
Rangierwagenheber / Service jack RWH125ALU - RWH180ALU - RWH250ALU
Seite 25