McLaren McS01 Installationshandbuch Seite 4

2. Lean-to-steer system (Image 4-5)
1. The system responds intuitively to the movement of the body:
• When the user leans to the right, the scooter turns right;
• When the user leans to the left, the scooter turns left;
2. STAGE 1. To set the lean-to-steer system to the full steering position pull up the
buttons, and at the same time move them to the position as illustrated in the below
image. (Image 6)
3. STAGE 2. To set the lean-to-steer system to the mid position pull up the button and
at the same time move the button to the middle position. (Image 7)
4. STAGE 3.To fully lock the lean-to-steer system pull up the buttons and move them to
the position as illustrated, this will make the scooter go in a straight line. (Image 8)
Image 4
Image 6
Directions:
• The scooter can be dangerous and can cause traffic accidents when used in public
places. Don't use on the public roads. It is best used on a flat or kids' playground,
clean surface, free of gravel and grease. Avoid bumps and drainage grates that may
cause an accident.
• Avoid hills and excessive speeds associates with riding downhill.
• The scooter does not include any lights. It is therefore not suited for use at night or
during periods when visibility is limited.
• Always use under adult supervision.
• Do not allow more than one person to ride the scooter at the same time.
5
Image 5
Image 7 Image 8
Before and after each usage
Make sure that locking mechanisms are surely lock
Check the height of the steering system and make sure that the nuts are tightened and
the handlebar and front wheel are perpendiculars.
The minimum height of the T-bar has to be locked at the lowest position by switching the
button into the lowest slot (Image 3)
Check all of the connection elements: the brake, the steering column's clamp, and the
wheel axles must be adjusted correctly and not damaged.
Also, check the wheel wear.
During the usage
• Standing on the scooter, one hand on each handle grip, push with one of your feet to
move forward. Proceed with caution at the start
• Braking: a brake is located at the rear, when necessary press down on it to slow
down. Press down gradually in order to prevent skidding or loss of stability
• Shoes are mandatory and we strongly advise you to wear trousers and long sleeve
shirts to avoid injury if you fall
Care/ Maintenance
Wheel bearings: avoid going through water, oil, or sand as this can damage wheel
bearings.
Cleaning: Clean the scooter with a soft cloth and a little water.
Designed for children over 3 years old.
Contains small parts. Use only under adult supervision.
If the logo is damaged, remove it from the scooter.
EN
6