McLaren McS01 Installationshandbuch Seite 3

Warning!
IMPORTANT
1. Not suitable for children under 36 months
NOTICE:
2. Protective equipment should always be worn
Please read the
3. Obey all local traffic and scooter riding laws and
manual carefully
regulations. Watch out for the other riders
and save it properly
and pedestrians
for later reference.
Remove the scooter and all the parts from the box.
Max weight: 50 kg
Set out all the parts and read the assembly instructions
prior to use. Keep the packaging until assembly
is complete.
Manufactured under license from McLaren Automotive Limited. "McLaren" is a registered
trademark of McLaren.
GENERAL INSTRUCTIONS MCLAREN
This scooter must be assembled by an adult. Prior to use, make sure that the scooter
has been assembled properly. Remove all the parts which are not necessary for use
before giving the scooter to the user. The scooter should be used with a caution since
skill is required to avoid fall or collisions causing injury to the user or third parties.
Always use suitable protective equipment, including a helmet, elbow, wrist and knee
protectors. Teach the user how to use the scooter safely and responsibly before use.
3
SCOOTER ASSEMBLY
1. Handlebar
1. Insert the handlebar into the hole at the front of the deck between the two front
wheels while paying attention to the direction of insertion.
2. Ensure the spring button pops out and locks the piece properly, as shown in Image 2
3. The handlebar has 2 positions for adjusting:
• Low positions: 61.5 cm
• High position 66.5 cm
4. Make sure that for the lowest position of T-bar, the button is locked into the lowest
slot (Image 3)
Image 2
EN
High position
Low position
Image 3
4