Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Do not mow when other people, especially children or pets, are nearby.
Do not start a damaged brushcutter.
Do not touch the cutting elements until the equipment is switched off and the motor of the device and cutting
elements do not stop completely.
Do not lift or carry the device with the engine running.
Turn off the brushcutter and remove the high voltage cable from the spark plug when:
you leave the equipment unattended,
before adjusting the lock,
before checking, cleaning or repairing the device,
after hitting with a foreign object,
in the event of abnormal vibrations.
National regulations may restrict the use of the machine.
PREPARATION
When mowing, always wear solid footwear and long pants, do not operate the device without shoes or wearing
sandals.
Check carefully the area where you will be working and remove all stones, branches, wires and other foreign
objects protruding from the ground.
In high grass, you may not notice obstacles (e.g. stumps, roots), so before starting work with the device, mark all
obstacles hidden in the grass that cannot be removed.
Always check the cutting elements for wear and damage before use. Replace worn or damaged knives, check the
cutting line and head for damage.
Check the centrifugal clutch before starting work. To do this, start the brusgcuter, press the throttle lever until the
brusgcuter engine reaches maximum speed, then release the throttle lever until the engine speed falls to idle. The
cutting tool should stop after a while. If the cutting tool does not stop, the cash register must be returned for repair.
Before use and after falling or other impacts, inspect the scythe to identify any significant damage that may affect
safety.
REMEMBER!
Do not leave the brushcutter uncontrolled. Never leave running equipment unattended, as unintended use may occur, which
may cause accidents.
USEAGE
Mow only in daylight or in good artificial light.
Do not mow during rain, especially during a storm. Avoid mowing wet grass.
Always make sure that your legs stand firmly on the slope.
Come on, never run. Remember to keep a secure position.
Do not mow on excessively sloping slopes.
Do not use the device with damaged covers or housings or without a safety device, e.g. attached covers.
Start the engine according to the instructions, making sure that the feet are away from the cutting tools.
Do not keep your hands and feet near rotating parts.
ATENTION! The device causes vibrations of the limbs during operation. The value of vibration acceleration is
provided in the table with rated data. Prolonged exposure of hands to vibration for several months or years, can cause the
white toe disease, i.e. a decrease in limb temperature caused by ischemia. Symptoms such as tingling, numbness,
hypersensitivity to cold should not be underestimated, see a doctor.
Correct posture during work is important, so as not to over-bother, frequent change of work position
is recommended.
Stop work every 15 minutes - rest is necessary. Tiredness and distraction can contribute to an accident.
Keep your feet steady and keep balance during work.
Always use the supplied suspenders.
List of recommended cutting attachments:
head with a cutting line,
Three-armed knife,
fork disc for brushcutters,
36
EN
Werbung
