BWT P450 Bedienungsanleitung Seite 3

Introduction
System overview
The robotic cleaner sweeps the pool floor and walls collecting dirt
and debris in its filter(s). This user manual explains how to operate
the robotic cleaner, including cleaning, maintenance and storage
procedures.
Robotic cleaner operation
Once the robotic cleaner is placed in the pool and activated, it
operates according to its program. It moves along the floor and
walls of the pool, covering the entire area of the pool floor and
walls. When it has finished its program, it remains inactive on the
pool floor. Power will automatically shut off.
Note: It's not recommended to stop the pool cleaner prior to cycle
end.
Note: The robotic cleaner climbs the wall at intervals according
to its internal program. Its ability to climb over stairs in swimming
pools is subject to stair geometry and material.
Operating conditions
The robotic cleaner is intended for use in residential swimming
pools only and in the following conditions:
(1) Recommended water temperature 13°C-35°C (55°F-95°F).
(2) Water pH : 7.2 - 7.6 (3) Chlorine level: pool is maintained
according to the pool manufacturer's instructions. (Recommended
Chlorine level: 2-4 ppm)
Note: Failure to maintain the pool according to the recommended
operating conditions could prevent the robotic cleaner from
functioning properly.
Components
P450 ROBOTIC POOL CLEANER
Power
supply
Robotic
pool
cleaner
3