Taurus ACCENTO LATTE Gebrauchsanleitung Seite 22

NOTE: The number of the coffee-brewing cycle will be
zeroed and recounted after a complete descaling is
finished. And the descaling prompt will occur when the
appliance has brewed 500 cycles of coffee cumulatively
again.
TROUBLESHOOTING
Problem
The Refill indicator (2.2) flashes.
The warning indicator (2.4) flashes.
The warning indicator (2.4) illumi-
nates solidly.
The No bean indicator (2.1) illumi-
nates solidly.
The Residue full indicator (2.5)
illuminates solidly.
The Brewer cleaning indicator (2.3)
illuminates solidly.
The single-cup espresso (4.8) and
warning indicator (2.4) flash at the
same time.
The No bean indicator (2.1) and
warning indicator (2.4) flash at the
same time.
The indicator of hot water (4.3) and
warning indicator (2.4) flash at the
same time.
Cause
The water tank lacks water.
The grind setting knob, door and
inner drip tray are not installed well
in place.
The brewer or inner drip tray is not
installed well in place.
The bean box lacks coffee beans.
The residue-collection container
needs to be cleaned.
The brewer needs to be cleaned.
The grinding motor does not work
normally.
It means that the appliance has
performed the bean-grinding for 16
cycles continuously, and the time for
each grinding is less than 5 minutes.
And then, the grinding system will
be forced to be cooled down for 5
minutes. At that time, all the functions
are invalid.
The flow meter has no signal, and the
water dispensing is abnormal.
Solution
Refill the water tank with water.
Please contact the service department
if the problem can not be solved.
Install the grind setting knob, door and
inner drip tray well in place.
Please contact the service department
if the problem can not be solved.
Install the brewer or inner drip tray well
in place.
Please contact the service department
if the problem can not be solved.
Fill the bean box with coffee beans and
then run the coffee machine to brew
coffee. Then the no-bean warning can
be cancelled.
Remove the residue-collection contain-
er and inner drip tray for cleaning. After
2 seconds, the Residue full indicator
(2.5) turns off.
Please contact the service department
if the problem can not be solved.
Remove the brewer for cleaning. After
2 seconds, the Brewer cleaning indica-
tor (2.3) turns off.
Please contact the service department
if the problem can not be solved.
Turn off the appliance and restart it.
Please contact the service department
if the problem can not be solved.
The appliance will rest for 5 minutes or
turn off the appliance and restart it.
2. Please contact the service depart-
ment if the problem can not be solved.
Fill the water tank with water.
Please contact the service department
if the problem can not be solved.