Seite 1
EN — NL — DE kms.vankronenburg.nl Pressure sensor 200 kPa Manual for installation, setup and calibration Handleiding voor installatie, instelling en kalibratie Anleitung für Installation, Setup und Kalibrierung...
Seite 3
EN — NL — DE kms.vankronenburg.nl Pressure sensor 200 kPa Part nr: 01-01-07-2012 Technical specifications and calibration values...
Seite 4
EN — NL — DE kms.vankronenburg.nl This document contains detailed information about the technical specifications and calibration values for the KMS pressure sensor 200 kPa. Additional information, user manuals, wiring examples ands software can be found on our website: kms.vankronenburg.nl Package contents •...
Seite 5
At 3.75 volt: 159 kPa • At 1.25 volt: 59 kPa When using a KMS ECU, these values must be set in the KMS ECU software. See figure below for an example: Engine-load 2’ values for software setup • Min. value: •...
Seite 6
Upper Limit at Uv = 5 V Volt 4.476 4.606 4.736 Response time 10/90 Warm up time Operating temperature Deg. C 0 to 85 Pressure Min. Value Max. Value 0-200 0-150 0-100 __________________________________________________________ KMS pressure sensor 200 kPa -01-07-2012 Version 2.00...
Seite 7
EN — NL — DE kms.vankronenburg.nl Alternative pressurescales KMS pressure sensor 200 kPa -01-07-2012...
Seite 8
EN — NL — DE kms.vankronenburg.nl Druksensor 200 kPa Onderdeel nr: 01-01-07-2012 Technische specificaties en kalibratie waarden...
Seite 9
EN — NL — DE kms.vankronenburg.nl Dit document bevat gedetailleerde informatie over de KMS druksensor 200 kPa. Overige informatie, handleidingen, kabelboomschema’s Inhoud van de kit • KMS druksensor 200 kPa • 3 polige contra stekker superseal druksensor 200 kPa handleiding Specificaties •...
Seite 10
‘Engine-load 2’ waarden voor software setup • Min. waarde: • Max. waarde: Wanneer er een KMS ECU wordt gebruikt, moeten deze waarden in de KMS ECU software worden ingesteld. Voor gebruik op lagere drukschaal, zie volgende pagina. Zie onderstaande afbeelding ter illustratie: __________________________________________________________ -01-07-2012...
Seite 11
Upper Limit at Uv = 5 V Volt 4.476 4.606 4.736 Response time 10/90 Warm up time - -40 Deg. C 0 to 85 Operating temperature __________________________________________________________ KMS druksensor 200 kPa Onderdeel nr: 01-01-07-2012 Version 2.00 Pressure Min. Value Max. Value 0-200 0-150 0-100...
Seite 12
EN — NL — DE kms.vankronenburg.nl Alternatieve drukschalen __________________________________________________________ -01-07-2012 Version 2.00...
Seite 13
EN — NL — DE kms.vankronenburg.nl Drucksensor 200 kPa Teilenummer: 01-01-07-2012 Technische Information und Kalibrierungswerte...
Seite 14
EN — NL — DE kms.vankronenburg.nl Dieses Dokument enthält detaillierte Information über den KMS Drucksensor 200 kPa. Weitere Informationen, Bedienungsanleitungen, Schaltpläne finden Sie auf unserer Website: kms.vankronenburg.nl Inhalt von diesem Kit • KMS Ducksensor 200 kPa • 3-poliger superseal Stecker •...
Seite 15
Bei 3.75 Volt: 159 kPa • Bei 1.25 Volt: 59 kPa Wenn ein KMS ECU verwendet wird, müssen diese Werte in der KMS ECU Software eingestellt werden. Siehe Abbildung unten für ein Beispiel: ‘Engine-load 2’ Werte für der Software Eindstellungen •...
Seite 16
Upper Limit at Uv = 5 V Volt 4.476 4.606 4.736 Response time 10/90 Warm up time Operating temperature Deg. C 0 to 85 Pressure Min. Value Max. Value 0-200 0-150 0-100 __________________________________________________________ KMS Drucksensor 200 kPa Teilenummer: 01-01-07-2012 Version 2.00...
Seite 17
EN — NL — DE kms.vankronenburg.nl Alternative Druckskala __________________________________________________________ KMS Drucksensor 200 kPa Teilenummer: 01-01-07-2012 Version 2.00...
Seite 19
Spaarpot-Oost 19 T +31(0)40 285 4064 5667 KT Geldrop E info@vankronenburg.nl The Netherlands W kms.vankronenburg.nl Please visit our website for more information, manuals, software and prices: kms.vankronenburg.nl...