WolfPack KWSD08 Bedienungsanleitung Seite 24

When the screw is completely screwed in, hold the machine firmly and release the On/
Off trigger, otherwise the screw or the screw head may be damaged. If the On/Off trigger is not
released immediately a high torque could also damage the screw bit or the screwdriver.
Screw removal
Set the direction of rotation of the screwdriver to the anti-clockwise direction. Insert the screw
bit into the slot in the head of the screw. Hold the screw bit perpendicular to the head of the
screw, otherwise the screw or the screw head may be damaged. Press the screw bit against
the screw with a constant pressure while removing the screw.
MAINTENANCE
Always remove the battery / unplug the item from the power source before maintenance.
All plastic parts should be cleaned with a soft damp cloth. Never use solvents to clean plastic
parts because these can cause damage to the item. Ensure that no water gets into the ma-
chine.
If anything unusual happens during use of the item, turn the item off. Pull the plug from the
power source and check the item thoroughly. If necessary, have the machine repaired by a
qualified technician before using it again. All repairs should be carried out by qualified techni-
cians. Repair or maintenance undertaken by unqualified persons can cause risk of injury or
damage.
Use only original parts for the repair of this tool.
STORAGE
Store the machine, the manual and accessories in the original packing. This way you always
have the necessary information on hand. Store the tool in a dry environment.
DISPOSAL
Do not dispose of this tool in household waste. According to the European standard
2012/19/EU for the disposing of electrical equipment (WEEE), it should be taken to your
local waste collection station and offered for recycling.
24