Werbung
flash. Press any key to stop the sound and
the symbol will disappear.
Semi-automatic time adjustment
(cooking period)
This function helps you to cook for a fixed
period of time. A time range between 0 and
10 hours can be set. Prepare the food for
cooking and put it in the oven.
1. Select the desired cooking function and
the temperature using the control knobs.
When the timer reaches zero, the oven will
switch off, an audible warning will sound
and the symbol "A" will flash. Turn both
control knobs to the "0" position and press
any button on the timer to stop the sound.
The symbol will disappear and the timer will
switch back to manual function.
2. Press "MODE" until
you see "dur" on the
screen. The symbol
"A" will flash.
3. Select the desired
cooking time period
using the "+" and "-"
buttons.
4. The current time of
day will reappear on
the screen, and the
symbols "A" and
will remain illuminated.
Sound Adjustment
To adjust the volume of the audible warning
sound, press the "MODE" button three
times while the signal is sounding. The
oven function selector knob must be at the
"0" position. "L3" will appear on the display
screen. Press the "+" and "-" buttons to
adjust the sound level. Release the buttons
and, after a few seconds, the signal sound
volume will be set.
4.4 aCCeSSorieS
The EasyFix Wire Rack
Clean the accessories thoroughly with
warm water, detergent and a soft clean
cloth on first use.
5
4
3
2
1
•
Insert the accessory to the correct
position inside the oven.
•
Allow at least a 1 cm space between the
fan cover and accessories.
•
Take care removing cookware and/or
accessories out of the oven. Hot meals
or accessories can cause burns.
•
The accessories may deform with heat.
Once they have cooled down, they will
recover their original appearance and
performance.
•
Trays and wire grids can be positioned
on any level from 1 to 5.
•
Telescopic rails can be positioned on
levels T1, T2, 3, 4, 5.
•
Level 3 is recommended for single level
cooking.
•
Level T2 is recommended for single
level cooking with the telescopic rails.
•
The turnspit wire grid must be
positioned on Level 3.
•
Level T2 is used for the turnspit wire
grid positioning with telescopic rails.
****Accessories may vary depending on the
model purchased.
EN - 16
T2
T1
Werbung
