Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Delay time for the switching output
dSx = switch-on delay; drx = switch-off delay
The output does not immediately change its switching status
when the switching condition is met but when the delay time
has elapsed. If the switching condition is no longer met when the
delay time has elapsed, the switching state of the output does
not change.
• setting range: 0 - 0.2 - 0.4 ... 9.8 - 10 - 11 - ... - 49 - 50s
• in steps of 0.2 or 1s
• indicated in seconds
Switching functions of the switching output
4 settings can be selected:
Hno = hysteresis / normally open
Hnc = hysteresis / normally closed
Fno = window function / normally open
Fnc = window function / normally closed
Damping for the switching output
Pressure peaks of short duration or high frequency can be filtered
out.
dAP-value = response time between pressure change and change
of the switching status in ms.
• the value for dAP defines the switching frequency (f) of the
output:
dAP
3
6
f [Hz]
170
80
10
17
30
50
30
16
60
125
250
8
4
2
500
1
23
Werbung
