Safety Instructions - Kruger & Matz KM2015 Bedienungsanleitung

Owner's manual

SAFETY INSTRUCTIONS

Installation precautions
• This unit is designed to operate on 12 V DC power supply. If your vehicle does not have
this system, a voltage inverter is required. The device also requires connecting to
negative of the car.
• Choose the mounting location where the unit will not interfere with the normal driving
function of the driver. Install the unit where it does not get in the driver's way and cannot
injure the passenger if there is a sudden stop. DO NOT install the unit or any cable in a
location where:
◦ it may obstruct the steering wheel and gearshift lever operations,
◦ it may obstruct the operation of safety devices such as air bags
◦ it may obstruct visibility
◦ there is not enough ventilation provided
• Avoid installing the unit where it would be subject to high temperature, such as from
direct sunlight, hot air, or a heater, or where it would be subject to dust, dirt or excessive
vibration. Do not expose this equipment to rain or moisture nor use near strong magnetic
fields. Do not handle this appliance with wet hands.
• Make sure all the connections are executed in a proper manner. Reversed connection will
cause short circuit and damage.
EN
• Before finally installing the unit, connect the wiring temporarily and make sure it is all
connected up properly and the unit and the system work properly.
• If the fuse blows, check the power connection and replace the fuse with one of the same
specified rating. If the fuse blows frequently, consult an authorized service point for
check-up/repair.
• To prevent short circuits, cover the terminals of the UNUSED leads with insulating tape.
• Make sure that the ignition is off before connecting the device.
16
• Make sure to connect the yellow and red power supply cables after all other cables are
already connected.
• The heat sink becomes hot after use. Be careful not to touch it when removing this unit.
• At the time of installation, be sure to fix all wires (wires both from this unit and from the
car itself) in a way that any wires cannot come into contact with heat sinks on the rear
and side of the unit.
• Installation illustrations show a typical installation. However, you should make
adjustments corresponding to your specific car. If you have any questions or require
information regarding installation kits, consult your car dealer.
• If you are not sure how to install this unit correctly, have it installed by a qualified
technician. Producer does not claim liability of incorrect mounting/installation nor for
inappropriate handling and use disregarding this user's manual.
• When mounting the unit, be sure to use the screws provided, as instructed. If other
screws are used, parts could become loose or damaged. Use only the parts included with
the unit to ensure proper installation. The use of unauthorized parts can cause
malfunctions.
• When tightening screws or bolts, be careful not to pinch any connection cord.
• Make sure not to block the ventilation outlets.
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the
unit will be seriously damaged.
• BEFORE connecting the speaker leads, check the speaker wiring in your car.
◦ Do not remove the housing/disassemble the device. The device has no user-
serviceable parts inside.
• In case of damage, contact an authorized service point for check-up/repair.
• If the vehicle has been parked for a long time in hot or cold environment, wait until the
temperature in the vehicle becomes normal before operating the unit.
Owner's manual
EN
17