Herunterladen Diese Seite drucken

Grundig electrinic GO 20Z Bedienungsanleitung Seite 13

Werbung

Zweikanal-Modul
Steuerungsfunktionen:
Betriebsart
beide Kanale aus
Die Taktimpulse kénnen mit der Zeitablenkung verkop- |
pelt sein (alternierend) oder von einem Rechteckgenerator
(Chopper) abgeleitet werden.
Da der Ausgang IC 303 B nur auf *'H''-Potential liegt, wird
das Gatter IC 303 C fiir die Chopperimpulse gedffnet.
Diese gelangen iiber IC 303 C an den Takteingang von
IC 301 A und werden auRerdem zum Dunkeltasten der Um-
schaitflanken gebraucht. Wird ein Kanal abgeschaltet, setzt
der Chopperoszillator aus. Auf diese Weise wird eine Strahl-
austastung bei Einkanalbetrieb vermieden.
Two-Channej Module
It is composed of TTL modules and controls the operating
modes one-channel operation (channel Yq or YB), alter-
nating operation and chopper operation. As a special case
both channels can be disconnected in the course of which a
line appears in the center of the screen.
For the alignment of the test prod as well as for possible
checking of the deflection coefficients, the module disposes
of a square wave generator (IC 302 B, C 301, R 301). To
shorten the rise time and to balance the square wave signal,
a flip-flop (IC 301 B) is switched after the generator.
Contro!] Functions:
Poe A
channe! YB on
oe
YA or
YB on
The first switch condition is of no importance at normal
operation. Switch conditions two and three are directly
dependent on the switches (S 203 b, S 202 b). The fourth
switch condition is indeterminate, the output positions
OQ and O/ IC 301 Achange after every clock pulse at pin 1.
The clock pulses can be coupled with the time base de-
flection (alternating) or can be derived from a square wave
generator (chopper).
At alternating operation connection 6 of the two-channel
module has to be put to low. By this firstly the chopper
oscillator (IC 302 A) is blocked and secondly the way
IC 303 B, 1C 303 C is released for the alternate pulse.
the chopper pulses.
lf the inputs 1, 2 and 4 (IC 302 A) : are at high, then the
chopper oscillator (IC 302 A, C 302, R 302) generates
square wave oscillations of appr. 200 KHz.
is avoided.
ae ic

Werbung

loading