Omnitronic CU-200 SP Bedienungsanleitung Seite 3

USER MANUAL
CONFERENCE SPEAKER UNIT
Conference Speaker Unit
The chairman speaker unit
condenser microphones with hypercardioid characteristic and are specially designed for use with the
conference amplifier CPA-5200
them with power. Delivery includes a windscreen.
Setting into Operation
Connect the connection cable of the first speaker unit with one of the speaker unit inputs GROUP 1 to 4 on the
conference amplifier. Then connect the connection cable of the second speaker unit to the feed-through jack of
the first speaker unit, etc. until all speaker units are interconnected to a row (max. 20 units). Repeat the steps
for the other speaker unit inputs GROUP 1 to 4 correspondingly. The speaker units can be connected within
the chain as desired. f required, extension cables available in 5 and 10 m can be used. The total cable length
from the conference amplifier to the last speaker unit must not exceed 180 m.
Operation
Ÿ
Adjust the gooseneck on the speaker unit so that the microphone points directly to the speaker. Place the
supplied windscreen.
Ÿ
Adjust the volume on the speaker unit with the control LEVEL.
Ÿ
The sum signal of the conference system can also be monitored via two sets of stereo headphones
connected to the jacks EARPHONES 1 and 2. The headphones level is determined by the setting of the
control LEVEL.
Ÿ
Switch on the microphone of the delegate speaker unit
conference amplifier registers the request to speak and the speaker unit is allocated a free transmission
channel. The light ring on the gooseneck and the LED next to the on/off switches light up red to indicate that
speaker unit can now be used to make announcements.
Ÿ
The number of delegate speaker units that can be used simultaneously depends on the operating mode
adjusted with the control
Ÿ
operating mode closed user group: If the maximum number is reached when switching on a further speaker
unit its function indicator will flash green and the conference amplifier does not allocate a free transmission
channel. Then a speaker unit must be switched off first before another unit can be switched on.
Ÿ
operating mode open user group: If the maximum number is reached when switching on a further speaker
unit all other speaker units are automatically switched off.
Ÿ
In order to switch on the microphone of the chairman speaker unit
light ring and the function LED light up red, and the speaker unit is allocated a free transmission channel by
the conference amplifier regardless of the operating mode adjusted for the delegate units.
Ÿ
The chairman speaker unit can take priority over the other speaker units. For this press the button PRIORITY.
Then all delegate speaker units will be switched off.
Technical Specifications
Type: .............................Condenser/hypercardioid
Frequency range: ..........100 Hz - 16 kHz
Impedance: ...................600
Sensitivity: ....................-44 dB
Power supply: ...............1.5 V DC , 0.5 mA via microphone line
Max. operating voltage: .10 V
Connections:.................1 x 8-pin DIN plug/1 x 8-pin DIN jack (microphone line)
......................................2 x 3.5 mm jack (headphones, min. 4 )
Speaker type: ................Full-range
Dimensions: ..................150 x 130 x 60 mm
Weight:..........................800 g
Please note: Every information is subject to change without prior notice.
CU-200 SP and the delegate speaker unit
. The amplifier offers connections for up to 60 speaker units and supplies
on the conference amplifier:
W
01.05.2010
CU-200 SP
DU-200 SP with one of the on/off switches. The
CU-200 SP
W
www.omnitronic.com
©
I DU-200 SP
DU-200 SP are gooseneck
press the button MIC. The
00053192.DOC, Version 1.2