Manta IRN910 Bedienungsanleitung Seite 9


Note: Before first use test with an old tissue whether the steam plate
and water tank are clean. Some parts have been slightly greased, thus
smoke can raise during first use. This should stop after some moments.

the iron must be used and rested on a stable surface;

when placing the iron on its stand, ensure that the surface on which the
stand is placed is stable;
The iron is not to be used if it has been dropped, if there are visible signs of
damage or if it is leaking.
 WARNING: Accessible parts may become hot during use. Young children
should be kept away.
 The instructions shall state that appliances are not intended to be
operated by means of an external timer or separate remote-control
system.
Use
Remove the protection film from the steam plate before first use.
You can use water directly from the tap. Special resin filter in the water tank
softens and prevents scale build-up on the soleplate. Do not use distilled
or demineralized water to prolong the life of the device.
Fill in water tank (for steam ironing)
Unplug the appliance an screw the temperature control (7) to position "0"
(minimal).
Fill so much water into the tank until the water-level is visible with horizontal
by hold tank in the middle of the transparent window.
Now connect the steam iron with a correctly installed power point.
Temperature control
Put the steam iron upright and select the desired temperature with the
temperature control (7).
By doing so pay attention to the care symbols on the textiles:
• Chemical fibred /synthetic
‥ Nature fibred/silk/wool
... Nature fibred/cotton/linen
Assort your steam laundry to texture and corresponding steam temperature,
iron the sensitive materials with the low steam temperature first as steam
iron gets essentially faster hot than gets cold.
User's Manual
9
E N