CONOPU DH-JSD03 Bedienungsanleitung Seite 6

Do not permit the area around the humidifier to become damp or wet. If
dampness occurs, turn the output of the humidifier down. If the humidifier's
output of volume cannot be turned down, use the humidifier intermittently.
Do not allow absorbent materials, such as carpeting, curtains, drapes, or
tablecloths, to become damp.
Unplug the appliance during filling and cleaning.
Never leave water in the reservoir when the appliance is not in use.
Empty and clean the humidifier before storage. Clean the humidifier before
next use.
SERVICING WARNING-TO reduce risk of fire, electrical shock and injury to
persons, observe the following:
Wash hands and avoid touching eyes after handling the wick (filter).
Clean your product regularly, only as is instructed in this manual. Prior to
cleaning, turn off the power on your product and unplug. Do not use gasoline,
thinners, solvents or other chemicals for cleaning. Refer to the CLEANING AND
MAINTENANCE instructions provided.
Do not open appliance housing while product is plugged in. To avoid risk of
shock, all service and/or repairs must be done by a Authorized Service
Center.
Protect against the growth of mold, mildew and other microorganisms by
empty ing the water tank immediatey after aech use. lf water is left in the
tank for longer than 8 hours, thoroughly clean and disinfect the unit as
described in the section of this user manual referenced as "CLEANING AND
MAINTENANCE".
PACKAGE RECYCLING-To reduce waster and environmental harm, observe
the following:
The packaging protects the appliance from transport damage. The packag-
ing materials are selected form the point of view of environmental friendliness
and disposal technology and are therefore recyclable. Dispose of all packag-
ing materials in an environmentally responsible manner.
SAVE THESE INSTRUCTIONS
BEFORE USING THE HUMIDIFIER
Before use, check appliance for visible damage. DO NOT USE if there is
evidence of damage. If any damage is found, contact Consumer Service.
Check for Leaks. Damage due to shipping may cause leaks in Base or Water
Tank. A visual inspection may not reveal hairline fractures. Fill Water Tank with
water to inspect for leaks.
Please install the product correctly according to the instructions, otherwise it
may occur electrical shock, fire, and injury to persons.
If the power cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
3
UK
UK