Inserting The Battery; Operating Mode Selection - Eternico AET-MSB550B Benutzerhandbuch

INSTRUCTIONS

Inserting the battery

Remove the battery compartment cover and insert a new AA battery. Observe the polarity
markings on the bottom of the battery compartment. Replace the cover.
The process is the same when replacing batteries, except that old batteries need to be re-
moved first.
Turning mouse On/Off
Turn the power switch on the bottom of the mouse to the "ON" position to turn on the mouse.
LED indicator 2.4G starts flashing.
Turn the power switch on the bottom of the mouse to the "OFF" position when the mouse
is not in use.

Operating mode selection

The wireless mouse allows you to set the operating modes 2.4G, Bluetooth 1 or Bluetooth 2.
The default operating mode is 2.4G.
1. Press the operation mode selection button repeatedly to select 2.4G, BT1 or BT2 mode.
The LED indicator of the selected mode flashes once.
2. Press and hold the operating mode selection button for more than 3 seconds (and until
the LED status light starts flashing rapidly) to enter the the Bluetooth operating mode. The
pairing time is 3 minutes.
3. On your computer, start searching for devices by clicking "Add device - Bluetooth". Select
the device named AET-MSB550B from the list of Bluetooth devices found.
4. If the pairing was successful, the LED indicator of the selected operating mode will go out
after approx. 2 seconds and the mouse cursor will appear on the display.
ENGLISH 7