Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION AND COMMISSIONING
SETTING UP THE SCREEN ORIENTATION
WARNING!: Do this operation
!
before installing the unit in its
location and with the power
source disconnected.
Fig. 3
Fig. 6
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
It is mandatory to respect the flow
direction marked on the input and
output connections, such as "IN" and
"OUT", otherwise the equipment will
not work. If due to the configuration
of your installation it is unavoidable
that the screen is reversed, you can
rotate
described below.
1
Fig. 4
2
3
1
2
Next figures show the difference between the default factory position and
the position once that the screen is rotated. Notice the new position of
fluid connections.
it following the procedure
4
FACTORY
POSITION
1. Loose the screws (1) and leave on
one side the front cover (2). Be
careful that neither the electronic
board nor the wiring is damaged.
(fig. 3).
2. Loose the screws (3) that attach the
plastic housing (4) (fig. 4).
3. Rotate 180 degrees the housing (4)
and attach it again using the screws
(3) loosen previously. Notice that only
3 of them are now needed (fig. 5).
4. Place the front cover (2) in its rigth
position and fix it by means of the
screws (1) (fig. 6).
Fig. 5
3
CONFIGURATION
ONCE ROTATED
R. 01/23 838 844
EN
3
Werbung
