Hesperide TONNELLE MALDIVES 4MX3M Bedienungsanleitung Seite 5

CARE INSTRUCTIONS
1/ Your product
Properties
Part of the frame is made up of aluminium parts (for its lightness) and epoxy painted steel parts
(for its sturdiness).
Aluminium is a light, resistant material that doesn't rust.
Epoxy steel is a steel covered with a protective paint against rust.
Polyester is a synthetic fabric that offers good resistance to tearing and rubbing.
Manufacturing and assembly
The manufacturing then assembly of this product requires leaving clearance between the
different parts.
It is therefore normal to observe gaps/slack that may reach several millimetres between the
different assembled elements (between two slats, between boards...).
This tolerance necessary for the correct realisation of your product can be behind little geometric
differences.
This does not lead to any loss of function of your product.
Irregular appearance
Each product is manufactured and assembled industrially from parts whose surface treatment is
carried out individually, before assembly. These metallic elements cannot be free from
appearance irregularities coming both from the surface treatment process and assembly
operations. The final appearance of the product is therefore directly linked to these possible
irregularities.
Regularity of seams
Although we pay special attention to the quality and regularity of seams, it is possible to notice
that some threads are not cut after the break point of the seam. There is no risk of the seam
becoming undone. Cut this thread with a simple pair of scissors.
Water evacuation
Eyelets are present to facilitate the evacuation of water and prevent it from gathering on the
cloth. It is therefore normal to observe the running off of rain by these eyelets.
2/ Precautions for use
We cannot guarantee the good behavior of this product under difficult atmospheric conditions.
We recommend dismantling the canvas during strong winds, thunderstorms, hailstorms or heavy
precipitation.
In these conditions, it is recommended not to be under or near the structure.
After each significant bad weather we invite you to check the general condition and the solidity of
the structure before use.
The accumulation of water, dead leaves or objects on the canvas contributes to its degradation
and to that of the structure: be sure to clean it regularly and remove any pockets of water that
may form.
We do not recommend mounting a light fixture or other heat source on the structure in contact
with or near the canvas.
Watch out for blows from knives and other sharp objects handled nearby. Watch out too for burns
from cigarettes and from other heat sources.
3/ Maintenance and ageing, siding
It is normal to note natural wear and tear of the product over time and with use, in the form of an
alteration of the colours and the state of the surface, the mechanical functions and tightening of
the screwed elements.