Klarstein VERDON Bedienungsanleitung Seite 22

EN
22
Important information on the fingerprinting process
• When using for the first time or when fingerprints are not set up, the device
can be unlocked with any fingerprint.
• The first two fingerprint accounts created are for administrators (power users)
by default.
• Up to 20 users can be set up with the fingerprint sensor (2 administrators and
18 user accounts).
• Do not create duplicate fingerprints.
• The setup of the 3rd to 20th fingerprints must be confirmed by the
administrator.
Status messages
Blue light stays on for 2 seconds
Red light flashes 3 times
Pink light flashes once
Delete all fingerprint accounts
Press any finger on the sensor and do not release the finger. The blue light flashes
three times during the period. Continue holding your finger until the red light
flashes three times prompting you to enter the administrator fingerprint twice.
The pink light will flash with each valid press. After releasing the finger, the blue
light will illuminate for 2 seconds, indicating that all fingerprints have been erased
and factory mode has been restored.
• The fingerprint was successfully
scanned.
• Fingerprint scanning has failed.
• System enters fingerprint enrolment
status.