Herunterladen Diese Seite drucken

Kenwood KD-727 Bedienungsanleitung Seite 6

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

rsd
In case of difficulty
If your unit should not perform as expected, consult the table below to see if the problem can be corrected before seeking help from
your dealer or service representative.
Symptom
No sound from both left and right chan- | 1. Turntable output cable or cables dis-
nels or one channel.
connected.
2. The function switch of the amplifier
is not set to PHONO MC.
Poor
connection
of turntable
output
cables.
1. Check connections to amplifier.
2. Set the function
switch
to PHONO
MC.
Make solid connections to amplifier.
Loud hum, no music.
Loud hum with music.
1. Turntable
output cable
picking
up
hum from AC cord.
1. Separate output cables from AC cord
or reverse AC cord plug.
2. The ground wire of the turntable is | 2. Connect the ground wire to the GND
not connected
to GND
terminal of
terminal of the amplifier.
the amplifier.
Buzzing noise with music.
Turntable output cable picking up TV | Relocate
output
cord
for
minimum
signal.
pickup.
Howling
drowns
out
music
when | Speaker vibration is picked up by turn- | Separate turntable from speakers.
volume is increased.
table.
Turntable platter does not turn.
Poor AC plug contact.
Check connection. Make sure AC outlet is
active.
Poor tracking.
Excessive dust on record or stylus.
Remove dust from stylus or record.
Specifications
Motor and turntable
Cartridge (except U.S.A.)
Drive System.............c0cceeees Quarts PLL Direct Drive
Furnished Cartridge.............. V-57 (Low Output Dual
Mototecs
oc scsrcci ccs ceaedeveeesetse Coreless & Slotless DC Ser-
Moving Coil Type)
vo Motor
Stylus i255. Seki iaitds
N-57 with 0.6 mil Diamond
Turntable Platter................. 30.0 cm (12") Diameter
Frequency Response............ 20 Hz to 20,000 Hz
Speeds................ Seneechaadete 2 Speeds, 33-1/3 and 45
Output Voltage................... 0.3 mV (1,000 Hz,
rpm.
5.0 cm/sec.)
Wow & Flutter.................068 Less than 0.025%
(WRMS)
Optimum Tracking Force....... 1.25+0.25 grams
Less than +0.05%
(DIN)
Load Impedance.................. 100 ohms
Rumble.............0.ccccseseeeecees DIN weighted better than
Replacement Stylus............. N-57
74 dB
:
Tonearin
Supplied accessory .............. 45 rpm Adaptor x 1
,
:
Auto size selector malfunc-
TYPO sesh ciscaccreedvehewerescseteese Static-Balanced Linear
tion prevention sheet x 1
Tracking Tonearm
"
Stylus Pressure................... 1.25 grams (Fixed)
Miscellaneous
Usable Cartridge.................. T4P Type
Power Requirements............ AC 120 V, 60 Hz...U.S.A.
Output Capacity.................. 170 pF (Headshell to Out-
& Canada Models
put)
AC 120 V/220-240V,
Dynamic Compliance ........... 7X 10° cm/dyne (with Fur-
50/60 Hz...Others
nished Cartridge as V-57)
Power Consumption............ 15 watts
Dimensions.................c2:0006 W
340 mm (13-13/32")
H
108 mm(
4-11/32")
D
345 mm (13-19/32")
Weight (Net)...................085 5.9 kg (13.0 Ib)
Note:
We follow a policy of continuous advancements in development. For this reason specifications may be changed without notice.
6 KD-727 (x)

Werbung

loading