Praher Plastics AQUASTAR mp6 pos Bedienungsanleitung Seite 20

 This equipment is not intended for it by persons (including children) with reduced physical,
sensory or mental abilities or for lack of experience and/or for lack of knowledge to be used
it is, it by a person responsible for their security is supervised or received from it
instructions, how the equipment is to be used. Children should be supervised, in order to
guarantee that they do not play with the equipment.
 The electrical installations must be carried out according to the respective local and regional
regulations (e.g. OEVE, VDE,...) and possible official regulations
 the electrical connection must have separating device built into the permanently installed
electrical installation, which enables the disconnection of all electrical contacts with a
contact space of min. 3 mm from the mains.
 Pay attention that the supply voltage is correctly protected and an earth-leakage circuit
breaker ≤ 30 mA is installed.
 Only use the equipment in dry rooms, in which no combustible gasses and vapors are
present.
 Do not put the equipment into operation immediately if it has been taken from a cold to a
warm area. The thereby developing condensation water could destroy your equipment
 If the equipment has visible damages, does not work anymore or has been stored under
adverse conditions for longer periods, then it is to be expected that a safe operation is no
more possible. In this case the equipment is to be secured against unintentional start-up
and if necessary to be decommissioned.
 Live parts can be uncovered when opening the cover or removing parts. Before an
alignment, maintenance, a repair or change of parts or devices, the equipment must be
separated from all voltage supplies, if opening the equipment is necessary. If after that an
alignment, maintenance or a repair on the opened equipment under voltage is inevitable, it
may only be done by experienced, skilled staff, which has knowledge of the associated
dangers and/or the relevant regulations.
 Capacitors in the equipment can still be charged, even if the equipment is separated from all
voltage supplies.
 Assembly and/or disassembly of the valve only in a pressure-free status (i.e. empty piping
beforehand)
 Valve flow and/or direction of flow must be considered.
Each person involved in the operation and maintenance of the equipment
must have read and understood the present operation manual!
www.praherplastics.com
All manuals and user guides at all-guides.com
It is for your own safety!
6