Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.15
E
N
2.16
G
L
I
S
H
2.17
36
All manuals and user guides at all-guides.com
3 - PROGRAM LEVEL #2
FLOW METER SIZE (F)
Not viewed in timeclock regeneration mode.
Press the button
. This parameter is identified by the letter "F". This option is used to set the
flow meter size. Seven settings are possible.
Standard 3/8"
Standard 3/4"
Standard 1"
Standard 1 1/2"
Standard 2"
Standard 3"
Not used
MIXING VALVE LOCATION (8)
Not viewed in timeclock regeneration mode.
Press the button
. This display is identified by the number "8". This option is used to indicate
where the mixing valve is located. Three settings are possible.
No mixing valve
Mixing valve before flow meter
Mixing valve after flow meter
SYSTEM TYPE (9)
Not viewed in RM version (Remote meter).
Press the button
. This display is identified by the number "9". This display is used to set the
type of system the valve is operating in. Two settings are available.
Single valves and 9000/9500: System #4.
Two valves interlocked regeneration: System #5.
Each 3200 ET timer generates a lockout signal whenever it is in regeneration. The other 3200 ET
timer will delay the start of regeneration until the lockout signal is removed.
Indication on each 3200 ET timer.
(1)
The unit of measure depends on the display format chosen.
All examples above are based on the cubic meter format (see point 2.12).
[F - - - - - 0]
[F - - - - - 1]
[F - - - - - 2]
[F - - - - - 3]
[F - - - - - 4]
[F - - - - - 5]
[F - - - - - 6]
[8 - - - - - 1]
[8 - - - - - 2]
[8 - - - - - 3]
[9 - - - - - 4]
[9 - - - - - 5]
3200 ET & RM
Werbung
