Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All manuals and user guides at all-guides.com
3 - PROGRAM LEVEL #1
Note:
1. Push the
button once
per display.
2. Option settings may be
changed by pushing the
and
set buttons.
3. Depending on current valve
programming, some
displays will not be viewed
or set.
(1)
The unit of measure depends on the display format chosen. All examples above are based on
the cubic meter format. (see point 2.12).
(2)
Only available with down flow regeneration valves and Twin valves (DF & UF).
For up flow regeneration valves, the cycles below apply to:
- Cycle #1: Brine draw & slow rinse
- Cycle #2: Backwash
25
The valve is in service position. To enter in the first
P
level, push and hold the
1.1. Water Hardness in °tH
P
Ex.: 30 °tH
1.2. Water Hardness after mixing valve in °tH
P
Ex.: 6 °tH
1.3. System capacity in m
P
Ex.: 1200 m
3
°tH
1.4. Regeneration time
P
Ex.: 2:00
R
EGENERATION CYCLE TIME SETTING
1.5. Cycle #1: Backwash for ET
P
Ex.: for ET:
for RM: 6 minutes compulsory
1.6. Cycle #2: Brine draw/slow rinse for ET
P
Ex.: for ET, not used for RM
1.7. Cycle #3: Rapid rinse
P
Ex.: for ET, not used for RM
1.8. Cycle #4: Brine refill
P
Ex.: for ET, not used for RM
1.9. Cycle #5
P
Ex.: not used
1.10. Cycle #6
Ex.: not used
P
Note: not viewed if cycle #5 is set on OFF.
Level #1 exit.
P
The valve returns in normal operation.
- Cycle #3: Rapid rinse
- Cycle #4: Brine refill
button for 5 seconds.
(1)
[- - - - - 30]
(1)
[P - - - - -6]
3
°tH
(1)
[- - - 1200]
[- - 2:00 - ]
.
, signal for RM
(2)
[ 1 - - 1 0 . 0 ]
[ 1 - - - 6 . 0 ]
(2)
[ 2 - - 6 0 . 0 ]
(2)
[ 3 - - 1 0 . 0 ]
(2)
[ 4 - - 1 2 . 0 ]
[ 5 - - O F F ]
[ 6 - - O F F ]
3200 ET & RM
E
N
G
L
I
S
H
Werbung
