Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8 TIPS ON SAVING ENERGY
8.1
Install it well.
Far from heat sources, from direct sunlight, in a well aired place and keeping free the space around from
engine compartment openings.
8.2
Close the lids.
Make sure that the lids are properly closed.
8.3
Defrost and clean the interior tank.
8.4
Keep the condenser clean if it has aluminum sheets.
9 WIRING DIAGRAM
It is printed on a sticker in the engine compartment.
10 MATERIAL AND ASSEMBLY INSTRUCTIONS
An insert in the present manual, gives you all the necessary information you might need, to complete the montage of
your freezer.
11 TROUBLESHOOTING GUIDE
Freezer does not operate
Temperature inside the freezer is too cold
Temperature inside the appliance is too warm /
Compressor seems to run too long
Popping or cracking when compressor comes on
Bubbling or gurgling sound, like water boiling
Vibrations
Moisture forms in frost on inside freezer walls
PROBLEM
POSSIBLE CAUSE
Not plugged in
The circuit breaker tripped or blown fuse
Compressor is out of order
Thermostat is not set correctly or is out of
order
A large amount of warm / unfrozen products
might have been stored recently. Wait until the
freezer reach its selected temperature
The lids are not closed completely
The condenser is covered with dust and dirt
(only for condensers with aluminum sheets)
The outside temperature is hotter than normal
There is not enough air circulation space in
front of engine compartment openings
The condenser fan motor is out of order
There is a refrigerant leakage in the circuit
This is normal. Sound will level off or disappear
as the freezer continues to run
This is normal. It becomes from the refrigerant
circulating
The freezer is touching the wall. Move it from
the wall
The freezer is not a level surface.
Weather is hot and humid, which is increases
internal rate of frost build up. This is normal.
6
Werbung
