Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 ELECTRICAL CONNECTION
4.1
WARNING / Fire hazard.
Do not use an extension cord. If not, you can cause electrical shock, fire, death. If the power cord is too short,
have a qualified electrician or service technician install an outlet near the freezer.
4.2
WARNING / Electrical shock hazard
Plug into a grounded wall outlet. Do not remove ground. If not, you can cause electrical shock, fire, death.
4.3
If the power cord is damaged, have it replaced by an authorized electrician.
5 TEMPERATURE CONTROL
5.1
The first time you turn on the appliance after a disconnection, for e.g. defrost, let it run for a few time before
putting the products inside. This will ensure the cabinet is thoroughly chilled before products is put in. During
some time the compressor will run constantly. This is normal.
Only for model: 7472.0115 – inverter edition.
5.2
The variable speed compressor offers maximum low energy consumption. This is achieved with the longest
duty cycle that the system allow in low rpm, avoided in this way to reduce the No of start-ups / stops of the
compressor. The compressor stop only for few minutes. This is normal. Also it is normal than when the
compressor starts for the first time, it will need some hours continuous running until its first stop.
5.3
The thermostat is located behind the engine compartment grill. The thermostat position No is pre-setted by
the manufacturer and normally can cover your needs. If you want to modify the pre-setted position No, you
have to turn the thermostat knob clockwise, from position 1 warmest temperatures to position 7 coldest
temperatures. We advise you to set it between 3 -4 position. For models with electronic thermostat conduct
with the supplier.
5.4
To turn the freezer off, turn the thermostat knob to 0.
5.5
WARNING / Setting the thermostat knob to 0 , you stop the cooling cycle but does not shut off the power
to the freezer.
6 DEFROSTING AND CLEANING YOUR FRREZER
6.1
Defrost and clean your freezer when frost has built up to about 15 mm thickness. If the area has too much
moisture, the freezer may need more frequent defrosting and cleaning.
6.2
WARNING / Unplug the freezer, before cleaning or defrosting.
6.3
WARNING / Do not places electrical devices such as fans air hair dryers in freezer for faster defrosting. You
can cause electrical shock or death.
6.4
Remove all frozen products for cleaning the frost. Leave the frozen products in another freezer or in a cool
area.
6.5
Leave lid open.
6.6
Open the defrost water drain tap ( located on the inner bottom ) and use a large sponge to remove water
faster.
6.7
Use a plastic scraper to remove frost.
6.8
DANGER / Do not use a knife or other sharp tools for defrosting. You can cause damage.
6.9
Use a soft sponge or cloth to clean the gasket.
6.10
When the interior of the freezer is dry, replace the drain tap.
6.11
Close the lid.
6.12
Plug in and turn on the freezer at least 1 hour before replacing the frozen products.
7 MAINTENANCE
If your freezer does not work or if it does not work properly, before calling for service, see the troubleshooting
7.1
guide on & 11.
If the condenser has aluminum sheets dirty or dusty:
7.2
WARNING, unplug the freezer from the power and clean them with a vacuum cleaner or soft paint brush.
Clean also the blades of the condenser ventilator by using piece of cloth.
7.3
WARNING / Other maintenance jobs can proceed only from authorized technicians.
5
Werbung
