Werbung
Verfügbare Sprachen
Verfügbare Sprachen
I
NSTALLATION
ATTACHMENTS WITHOUT ARMS
Attachments without arms are supplied with two arm
bases. Special forks can be welded directly to the arm
bases or they can be used as a base to fabricate custom
built arms.
WARNING: Cascade requires that a
qualified or certified welder experienced
in this type of fabrication be used for best
quality.
CAUTION: Weld fabricated arms to the arm bases only.
Do not weld or bolt special built arms or forks directly to
the arm bars.
The arm base material is AISI C-1020 HR with the following
specifications:
• TENSILE STRENGTH – 420 mPa min.
• YIELD STRENGTH – 300 mPa min.
• CARBON CONTENT – 23% max.
CAUTION: The surface flatness of the arm base must
remain within 0.25 mm in capscrew area and arm must
slide manually.
1
Fasten the arm bases to the arm bars. Use drive
extension tool, Cascade part no. 6040284
(14 mm) or 6040285 (17 mm), to clear arm bars and
tighten capscrews to the following torque:
20G, 28G – 275 Nm
36G, 44G, 52G – 535 Nm
64G, 70G, 77G – 585 Nm
IMPORTANT: Be careful not to damage the arm bar.
Premature bearing failure will occur.
Drive extension tool dimensions are provided to
fabricate the tool from an Allen wrench. Do not use
mild steel hex stock which will not withstand the torque
value required.
2
Place the rod ends on the cylinder rods. Install the split
ring keepers.
3
Install the anchor bar through the cylinder rod end
and fasten to the arm anchor. Tighten the anchor bar
capscrews as follows:
20G – 63 Nm
28G, 36G – 90 Nm
44G, 52G, 64G, 70G, 77G – 225 Nm
4
Lubricate the bearing surface of the arm bars with a
light application of teflon lubricant (Cascade part no.
6850769 or Dupont D00080101).
6033701-R6 EN
WARNING: Rated capacity of the truck/
attachment combination is a responsibility
of the original truck manufacturer and may
be less than that shown on the attachment
nameplate. Consult the truck nameplate.
Drive Adapter
1
Arm Bar
Arm Base
A
B
Hex
Model
A
B
20G
14 mm
13 mm
28G
36G
44G
52G
17 mm
13 mm
64G
70G
77G
Split
2
Ring
Keepers
3
CL2532.eps
C
63
D
CL0456.eps
C
D
11.3 mm
90 mm
14.5 mm
90 mm
CL2624.eps
9
Werbung
