Upper part of
the housing
Cover screw
Front view
Molds for the
rubber pads
Base part of
the housing
Back view
18
All manuals and user guides at all-guides.com
Opening for
the mounting
screw
Hanging
Electrical connection
ATTENTION
! ESD damage!
Electrostatic discharge can lead to damage
to electronic components!
Î Take care to discharge properly before
touching the inside of the device!
ATTENTION
! Short circuit!
A short circuit can lead to damage to elec-
tronic components!
Î Finish terminal connection and close
the housing before establishing the
mains connection!
The VBus
/LAN interface adapter needs a mains, a VBus
®
and a LAN connection to function. To install the VBus
the housing has to be opened.
Î To open the housing, unscrew the cover screw and pull
off the upper part of the housing
Î Connect the included VBus
nals with either polarity
The VBus
cable can be extended or replaced with a two-
®
wire cable (bell wire). The cross section of the cable must
be at least 0.5 mm
and the cable can be extended up to
2
50 m in the case that one module is used.
®
cable,
®
®
cable to the VBus
®
termi-