Technical Data - Aritech Rk100-N Kurzanleitung

Switching points
Details can be found at Figure 6.
It is possible to adjust the switch point of the bolt contact with a
locking disk on to the designated switch point.
Set the switch point 1 until 4 with the tip of a screwdriver. Raise
the locking disk on the notch and turn until it engages again.
Schematic

Technical data

Item No. RK100-N
Contact termination 3 soldered terminals
Protection category IP50/DIN 40050; VdS environmental class II
VdS Class C
VdS No G 110103
Designated use For mounting on interior doors
Contact capacity max. 3 W / VA
Switch voltage max. 30 VDC
Switch current min. 5 mA
Switch current max. 300 mA
Contact type Change over
−25°C to +70°C
Temperature at fixed
cable
−5°C to +50°C
Temperature at
moveable cable
Switch point Adjustable
Cycles of operation min. 30,000
Regulatory information
PLACED ON THE MARKET BY:
Manufacturer
Carrier Fire & Security Americas Corporation Inc.
13995 Pasteur Blvd
Palm Beach Gardens, FL 33418, USA
AUTHORIZED EU REPRESENTATIVE:
Carrier Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Certification
P/N 75007040.Y71 • REV C • ISS 11DEC20
Product warnings THESE PRODUCTS ARE INTENDED FOR
and disclaimers SALE TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. CARRIER FIRE &
SECURITY CANNOT PROVIDE ANY
ASSURANCE THAT ANY PERSON OR ENTITY
BUYING ITS PRODUCTS, INCLUDING ANY
"AUTHORIZED DEALER" OR "AUTHORIZED
RESELLER", IS PROPERLY TRAINED OR
EXPERIENCED TO CORRECTLY INSTALL
FIRE AND SECURITY RELATED PRODUCTS.
For more information on warranty disclaimers and
product safety information, please check
https://firesecurityproducts.com/policy/product-
warning/
European Union Carrier Fire & Security hereby declares that this
directives device is in compliance with the applicable
requirements and provisions of the Directive
2014/30/EU and/or 2014/35/EU. For more
information see www.firesecurityproducts.com or
www.aritech.com.
Product may contain substances that are also
REACH
Candidate List substances in a concentration
above 0.1% w/w, per the most recently published
Candidate List found at ECHA Web site.
Safe use information can be found at
https://firesecurityproducts.com/en/content/intrusi
on-intro
2012/19/EU (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European Union.
For proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
www.recyclethis.info
Contact information
For more information visit our website:
www.firesecurityproducts.com.
DE: Montageanleitung
Montageort
Der Riegelschaltkontakt ist zur Montage u.a. im
Türschließblech zur Verschlussüberwachung der Verriegelung
geeignet. Die Betätigung des Riegelschaltkontaktes erfolgt
durch den Schloßriegel. Die Meldung kann für
Einbruchmeldeanlagen und Überwachungssysteme
ausgewertet bzw. angezeigt werden.
Lieferumfang (siehe Abbildung 2)
1. Riegelschaltkontakt
Hebelverlängerung (Kunststoff)
2.
Hebelverlängerung (Metall)
3.
4. Kunststoffhalter
5. Blechschraube 2,2 x 4,5
6. Senkkopfschraube M3 x 6
or scan the QR code.
3 / 6