Calibration - Ten-Haaft SunMover Bedienungsanleitung

Calibration

Objective / topic
Your SunMover® also uses an electronic compass sensor to keep the solar module
correctly aligned towards the sun at all times.
E
This sensor has been calibrated at the factory, so the system should work wit-
hout problems in most cases.
However, motor vehicles often exert a certain infl uence on the function of the
compass sensor by slightly distorting the geomagnetic fi eld.
Your system uses an automatic calibration routine to continuously adapt to any
changes in conditions. This means that when the system is in normal operating
mode, you can always rely on the solar panel being correctly aligned towards the
sun. However, it is completely impossible to anticipate the magnitude of any exter-
nal infl uence on the system in every specifi c case.
We therefore recommend that a one-off calibration of the system is performed
after installation.
In cases where the system detects a strong external infl uence, this calibration will
be expressly requested by the microprocessor.
Condition / preparation:
To perform the calibration you will need a large enough open space where you can
perform the manoeuvre without disturbing or obstructing other road users.
Procedure:
To perform the calibration, start the vehicle in a suitable place. The control panel
Ignition on
should now display the message .
CAL x/y:.....
Repeatedly press until the message appears on the display.
You can now start the calibration mode by pressing button and at the same
CALIBRATE
time. The message is displayed as confi rmation.
45