Husqvarna LB 146i Bedienungsanleitung Seite 14

• Do the maintenance work
correctly to increase the
lifetime of the product and
decrease the risk of accidents.
Let an approved service agent
do the professional repairs.
Speak to your nearest service
agent for more information.
• Only do the maintenance work
written in this operator's
manual. More extensive work
must be done by an approved
service agent.
• Put on heavy duty gloves
when you use the cutting
equipment. The blade is very
sharp and cuts can easily
occur.
• Keep the cutting edges sharp
and clean for the best and
safest performance.
Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
To assemble the handle
CAUTION:
1. Align the holes in the upper handle with the holes in
the lower handle.
14
All manuals and user guides at all-guides.com
Assembly
Before you assemble the
To prevent accidental start
Do not twist the cables.
• Let your service agent
regularly examine the product
and make necessary
adjustments and repairs.
• Replace damaged, worn or
broken parts.
• Obey the instructions for how
to change accessories. Only
use accessories from the
manufacturer.
• When not in operation, keep
the product, battery and
battery charger apart in a dry,
indoor and locked area. Make
sure that children and persons
that are not approved cannot
get access to the product,
battery or battery charger.
2. Tighten the knobs on right and left sides fully and
fold the handle up. (Fig. 23)
3. Put the stay in the groove on the cutting cover. (Fig.
24)
4. Attach the 2 stops that lock the stay and the handle.
Push them fully into position. (Fig. 25)
Note:
There are 2 stops, one identified with an H
and one with a V. Put the stop with an H on the right
side and the stop with a V on the left side.
CAUTION:
product if the 2 stops are not attached.
To adjust the handle height
1. Remove the handle stay from the lower handle. (Fig.
26)
a) Put the handle stay in the top hole (A) to
decrease the handle height.
Do not operate the
1680 - 002 - 13.10.2021