Dell PowerEdge UCP-50 Bedienungsanleitung Seite 5

Removing and Installing the
Battery and Battery Cable
on PERC Controllers
This document contains information on removing and installing the battery,
battery cable, and memory module on Dell™ PowerEdge™ Expandable RAID
Controllers (PERC).
• See page 4 for PERC x/E, where x is the generation of the card (i.e., 5, 6, etc.)
battery removal and installation procedures
• See page 10 for PERC x/i battery removal and installation procedures
Important Safety Information
CAUTION:
Any installation that requires removal of the system cover is intended solely
to be performed by trained service technicians. See the Product Information Guide that
came with your system for complete information about safety precautions, working
inside the computer, and protecting against electrostatic discharge.
NOTE:
See the Product Information Guide that came with your system for complete
information about U.S. Terms and Conditions of Sale, Limited Warranties and
Returns, Export Regulations, Software License Agreement, Safety, Environmental
and Ergonomic Instructions, Regulatory Notices, and Recycling Information.
Removing and Installing the Battery and Battery Cable on PERC Controllers
3