AUTO-HAK C27 Montageanleitung Seite 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
A
5
M10x35
B
6
C
M12x35
This towbar is designed to assembly in following cars:
FORD FOCUS I, 3/5 doors (Mk1), except ST and RS, produced since
10.1998 till 10.2004, catalogue no. C27 and is prepared to tow trailers max
total weight 1400 kg and max vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
A
4
Washer
ø30xø10.5x2.5
M10x35
1
M12x75
3
From manufacturer
1. Disassemble the rear bumper and then unscrew the metal profile.
This profile will not be reassemble.
2. Lower the silencer from the rubber handle and remove the thermal
M12x35 silencer protection.
3. Put side brackets (pos. 4 and 5) to chassis members and then fix
loosely through holes (pos. A) using bolts M10x35mm (pos. 10).
Attention! Use jibs with nuts (pos. 6).
4. Fix loosely through holes (pos. B) using M10x35mm (pos. 10), but
through holes (pos. C) fix using nuts M8 (use from the unscrewed
metal profile).
5. Position the main bar of the towing hitch (pos. 1) between mounted
brackets (pos. 4 and 5) and fix with M12x35mm (pos. 9) from the
M12x70
towing hitch accessories.
17
6. Reassemble the rear bumper
7. Position the ball of towing hitch (pos. 2) with socket plate (pos. 3)
and fix with bolts M12x75mm (pos. 7) and M12x70mm (pos. 8)
from the towing hitch accessories.
8. Tighten all nuts and bolts according to the torque shown in the table.
9. Connect the electric wires according to the instructions of the car.
2
10. Complete the paint cover of towbar (during the mounting paint cover
could be destroyed).
After install the towbar you should get adequate note in registration book
(at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all screws. The ball of towbar must be always kept
clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE