Kenwood KD-48F Bedienungsanleitung Seite 9

Operating instructions
Ш Preparation for operating
Turn the power on and place a record on the turntable.
c3 со
tr e _ Ш Automatic play
EN 1. Select 33 1/3 or 45 by pressing the SPEED key.
2. Press the PLAY/CUT key.
€ Playing starts from the first selection and continues to
the last, then the tonearm returns to the arm rest and
the turntable stops.
PLAY/CUT
3. Control the volume with the VOLUME control on the am-
plifier.
[ 1 e While playing, pressing PLAY/CUT or any INPUT key (ex-
cept PHONO on the amplifier) stops the play (when the
unit is connected in the system control configuration),
and the tonearm returns to the arm rest and the turnta-
ble stops.
Note:
Manual operation is necessary for 25 cm records or other odd sizes.
B Manual play
1. Use operation 1 of the "Automatic play'' procedure.
2. Release the tonearm from the arm rest and confirm that
the CUEING lever is set to У'.
€ Swing the tonearm to the starting position.
14
3. Set the CUEING lever їо "Y".
Y € This puts the tonearm on the record and playing starts.
At the end of the record, the tonearm returns to the arm
rest and the turntable stops.
|
V 4. Control the volume with the VOLUME control on the am-
plifier.
Note: - = = -
When the PLAY/CUT key is pressed with no record оп the platter,
the platter starts rotating, then stops automatically.
After play or during play, do not turn the power off
until the tonearm returns to the arm rest and platter
stops completely.