Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Operating instructions
Maintenance
Ш To stop the play temporarily
Set the CUEING lever to '' V '' to momentarily stop playing.
The tonearm leaves the record.
To restart playing, set the CUEING lever їо 'У ''. The record
play resumes at over near the same position.
Obtain the optionally available
таг
ММ саг-
tridge. -
:
m
| With this unit, an MC type cartridge cannot be used.
B Motor lubrication
The motor employs
permanently-lubricated
bearings.
It will
operate for more than 20,000 hours without attention to lubri-
cation.
B Periodic check-up
Because a turntable is a mechanical device, it is subject to the
effects of wear and misadjustment that occur during normal
handling and operation. Even if your unit appears to function
normally, a periodic check-up at intervals of two years or so
is recommended
to ensure
a long service
life and
proper
operation.
Check with your dealer or authorized service representative.
Ш Stylus replacement
A replacement stylus can be obtained from your local dealer.
Always obtain the specified N-67BL stylus. When replacing the
stylus, take care not to damage the stylus tip. The figure be-
low shows how to replace the stylus.
Note:
——
———
--
СЕСЕ
Be sure to turn off the power of the amplifier when replacing the
stylus.
Pull out the stylus in the
direction of the arrow.
B How to replace the cartridge
1. Remove the cartridge locking screw. (To protect the sty-
lus, remove the stylus assembly beforehand.)
2. Pull out the cartridge from the tonearm.
@ To install the cartridge, align the pins of the cartridge with
the connector of the tonearm
and securely insert.
Locking screw
Pull out the stylus cover
in the direction of the arrow.
Werbung
