AUTO-HAK R27A Montageanleitung Seite 4

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
11
13
7
9
14
A
8
5
12
10
This towbar is designed
FIAT DOBLO, VAN, also MAXI, produced since 01.2001 till 09.2005 and
10.2005 till 12.2009, catalogue no. R27A and is prepared to tow trailers max
total weight 1300 kg and max vertical load 60 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right operation.
For this reasons we kindly ask to read carefully this instruction and apply to hints.
The towbar should be install in points described by a car producer.
11
9
8
6
13
1
3
12
14
to assembly in following
From manufacturer
1. Disassemble the bumper.
2. Disassemble the metal strengthener (will not be assembled again).
3. From under the car, on the transverse frame, are a plastic fuses in the left and right side.
Open it an then, form inside of the carrier, put out the rubber dummy. It in this way get
through holes, and then put from the under side the tubes ø20x3, L=80mm (pos. 9), and
twist with bolts M10x110mm (pos. 12) and washer (pos. 10), as showed on the drawing.
A
12
12
4
14
4. In the place previously metal strengthener, put the elements (pos. 5 and 6) and twist with
bolts M8x35mm (pos. 15) from the front, and form under of this, with bolts M10x35mm
(pos. 14) - loosely.
5. For this way prepared elements, put the main bar of the towbar (pos. 1) and twist with bolts
M12x35mm (pos. 13).
6. To elements (pos. 5 and 6) through the holes (pos. A) fix the brackets (pos. 7 and 8) with
bolts M12x35mm (pos. 13) and previously put bolts M10x110mm (pos. 12) and twist with
chassis member.
2
7. Fix tight, all nuts and bolts with the moment showed in the table.
8. Mount the bumper after previous cut a fragment, how is showed on fig. 2.
Fig. 1
9. Fix body of the automat and place tow-ball according to supplied instruction. Note!
cars:
Remember to place socket plate (pos. 3) as shown on the drawing 1.
10. Connect the kit wires to the electric installation, in accordance of the instructions of the
car.
11. Complete the possible decreases of the paint cover of towbar, originate during the
mounting.
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book (at authorised service
station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be always kept
clear and conserve with a grease.
The instruction of the assembly
bumper axis
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
Fig. 2 Cut area
M10 - 50 Nm
M16 - 210 Nm