G21 Envi 12H Bedienungsanleitung Seite 9

Maintenance
Cleaning: Before cleaning and maintenance, turn off the machine amd unplug the plug.
Clean the surface
Clean the surface of the machine with a wet soft cloth. Do not use chemicals, such as benzene,
alcohol, gasoline etc. Otherwise, the surface or even the whole machine will be damaged.
Clean the filter screen
If the filter screen is clogged with dust, the effectiveness of the machine is reduced. Clean the filter
screen once every 2 weeks.
1
2
2
1. Retaining screw
2. Wedging block
Cleaning the upper filter screen frame
Clasp the wedging block with hands. Force down from the outside to remove the filter screen
frame. Unscrew 4 screws from the rear housing.
Put the filter into warm water with neutral detergent (about 40°C/104°F) and then dry it.
Cleaning the lower filter screen frame
Hold the filter screen frame and pull it outward gently to remove it.
Put the filter into warm water with neutral detergent (about 40°C/104°F) and then dry it.
Postseason storage
Unscrew the drainage cover and discharge the water into the water container. You can slightly tilt
the body to dischrage the water.
Turn on the machine, adjust it to low-wind ventilation mode and wait until the drainage pipes
become dry, so as to storage the machine dry and prevent it from mildewing.
Turn off the machine, unplug the power plug and wrap the power cord around handles in the back
side of the machine and install the drainage cover.
Remove the exhaust pipe and keep it properly.
Cover the air conditioner with a plastic bag so as not to be dusty and place it into dry place and
keep it out of reach of children.
Remove the batteries from the remote control.
Notice
Ensure that the body is placed in a dry place and keep all components properly.