Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Instruction Manual 4 channel transmitter for LAMA
Specifications:
System:
Modulation:
Operating frequency:
Functions:
Operating power:
Overview
Picture 1
Hook
Switch (inherent)
Stick for Throttle
and Rudder
Trim Lever
ON/OFF Switch
Transmitter Description:
This transmitter is a 4 channel hand transmitter intended for the „Lama" helicopter model.
For easy servo adjustment the radio offers servo reversing on all 4 channels by using the
servo reversing switches (DIP-switches).
The trainer jack offers connection via interface cable to your home computer. You then can
use the radio with R/C flight simulators like Aerofly Professional Deluxe or Easyfly2 with the
optional adapter # 31036. With the help of these outstanding software programs you can ea-
sily learn how to fly a model plane or helicopter. Use the experience from your flight simulator
effortlessly on the field without fearing the loss of your valued model.
Safety Instructions:
Before using the transmitter insert the antenna into the antenna slot and screw tightly.
Tighten the telescope antenna until you can feel a firm resistance. Always extend the
antenna in its entire length before flying a model. Make sure the throttle stick is in the
minimum i.e. throttle stop position before switching the transmitter on. The throttle
trim lever must also be in the minimum (down) position. Always switch the transmit-
ter on first, then the receiver and the model. After your flight proceed in the opposite
order, i.e. turn off the receiver power switch, then turn off the transmitter. Caution: A
failure to operate in this order could lead to an unintentional run of the main engines.
Injuries or the destruction of the model could result!
4 channel transmitter
FM (PPM)
72 Mhz
4 servos
9.6 – 12 Volt
7
Antenna
Level meter voltage
Trainer Jack
Switch (inherent)
Stick for Nick and
Roll
Trim Lever
Werbung
