Led Indications - Nibe Rpp 10 Benutzerhandbuch

Connection
Pairing is performed in the heat pump's/control module's
display, select menu 5.4 – Connect wireless units.
PAIR YOUR WIRELESS ACCESSORY WITH YOUR
MAIN PRODUCT
Main product
MENU 5.4 – CONNECT WIRELESS UNITS
WIRELESS UNITS
Room sensor
RPP 10
Add unit
Here, you connect your wireless units. Press "Add unit" and
follow the guide that is launched. You can also check the
connected units' battery level and signal strength.
CONNECT TO NETWORK
RPP 10 must be connected to an outlet in order to connect
to a network.
If RPP 10 is flashing red (once every five seconds), it is
searching for a wireless network to connect to. If no network
is found, searching stops after 5 minutes. You can start a
new search by pressing and holding the button on RPP 10
for 3 seconds.
If you need to test the range of the signal, RPP 10 can be
connected to the heat pump at close range and then moved
further away. Wait for at least 30 minutes. The signal
strength can then be read off in the heat pump's/control
module's menu system (menu 5.4).
To leave a network and reset RPP 10, press and hold the
button for 10 seconds and wait until the red LED comes on
for 5 seconds.
12
LOCATION
Place RPP 10 in a free space to achieve the best range; you
should therefore avoid locations such as between shelves
and behind curtains. In a free space, RPP 10 has a maximum
range of 30 m.
Wireless accessory

LED INDICATIONS

1 2
3
Main product
LED
Red LED comes on for five
seconds
Red LED flashes once every five
seconds
Red LED flashes once every
second
Red LED flashes three times
within five seconds
Green LED comes on
Green LED does not come on
1 2
3
Repeater
Explanation
Factory reset
Connecting to network
The unit is overheated
Lost connection or unit is not
connected to network
Relay ON
Relay OFF
RPP 10 | EN