Hillrom O-PRSLH Gebrauchsanleitung Seite 14

INSTRUCTIONS FOR USE
3 Equipment Setup and Use:
Prior to use:
a. Inspect the product looking for any visible damage or sharp edges that could
be caused by a drop or impact during storage.
b. Make sure product has been properly cleaned and disinfected and wiped dry
prior to each use.
Setup:
1. Place the padded area of the Restraint Strap at
the desired location on the patient. Drape the
Restraint Strap on both sides of the patient.
2. Loop the end of the Strap down between the
Surgical Table and the Accessory Rail, then back
up on the outside of the Accessory Rail.
3. Lift up on Cam Buckle and thread the Strap
through. Pull Strap to adjust tension.
Installation and use of Rail Hooks (Optional)
1. Thread one end of the Strap through one of the Hooks.
Lift up on Cam Buckle and thread the free end of the
Strap through. Note the orientation of the Clip to the
Buckle. This orientation is the same on both ends.
Repeat for the other end of the Strap.
Document Number: 80028144
Version C
Page 14
Issue Date: 30 MAR 2020
Ref Blank Template: 80025117 Ver. F