SW-Motech GPT.06.871.65000/B Anbauanleitung Seite 42

3
Installing lock casing connector
 NOTE: If you have opted for the DUSC lock set, this step is not necessary.
Install the lock set instead.
3.1 - Open the DUSC latch buckle (1) and position the latch housing connector
(3) as shown.
 NOTE: Make sure the locking tab is in the unlocked (up) position. If necessary,
the locking tab must be pushed up into the unlocked position.
3.2 - Push the latch housing connector (3) down until it clicks into place.
3.3 - Screw in the latch housing connector (3) using the screws (4) and the
torx key (5). Carefully tighten the screws by hand.
 WARNING: Over-tightening the screws may damage the lock casing!
 NOTE: Ensure that the locking mechanism is in working order!
The content translation is automated.
© SW-MOTECH GmbH & Co. KG
MOUNTING STEP · READ AND KEEP MOUNTING INSTRUCTIONS!
6
1
3
×
2
4
×
1
5
×
Errors and omissions excepted
Subject to technical and design changes.