SW-Motech HDG.00.220.38100/B Anbauanleitung Seite 60

1
 WARNING: Always wear eye and hand protection!
 WARNING: Always use the proper tools!
 NOTE: Assembly is shown on the left side. Repeat the assembly with the
corresponding parts on the right.
 NOTE: Pay attention to the L marking (left) or R marking (right) of the plastic
caps (3/4)
Insert the plastic caps (3/4) into the openings of the Adventure hand-guard shells
(1/2).
Screw the Adventure hand-guard shells (1/2) onto the brackets (*).
Carefully tighten the screws (5) hand-tight (max. 1.5 Nm).
 WARNING: Tightening too tightly can damage the plastic parts!
The content translation is automated.
© SW-MOTECH GmbH & Co. KG
MOUNTING STEP · READ AND KEEP MOUNTING INSTRUCTIONS!
4
1
1
×
1
2
×
1
3
×
1
4
×
4
5
×
8
6
×
Errors and omissions excepted
Subject to technical and design changes.