SW-Motech HDG.00.220.38100/B Anbauanleitung Seite 35

1
 WARNING: Always wear eye and hand protection!
 WARNING: Always use the proper tools!
 NOTE: This is a mounting kit supplement. Use the parts (*) from the actual
assembly set, and mount them with the parts included at the location on the
handlebar shown. The parts not listed are not required during assembly.
 WARNING: Be sure to observe all instructions given in the installation
instructions for the assembly kit, and follow them as indicated.
 NOTE: Assembly is shown on the left side. Repeat the assembly with the
corresponding parts on the right side of the handlebar.
 NOTE: The handlebars shown here serve as an example.
Screw the brackets (*) to the parts shown at the end of the handlebar.
 WARNING: Use a liquid threadlocker!
Tighten the screws (1) as specified in the installation instructions.
The content translation is automated.
© SW-MOTECH GmbH & Co. KG
MOUNTING STEP · READ AND KEEP MOUNTING INSTRUCTIONS!
4
2
1
×
8 Nm
2
2
×
Errors and omissions excepted
Subject to technical and design changes.